Additional Instructions For Fastening Devices Powered By Compressed Air; Fire And Explosion Hazard - Parkside PDT 40 F4 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

 Additional instructions
for fastening devices
powered by compressed
air
DANGER OF INJURY!
Do not operate the device if
the trigger safety catch
defective or has been
removed. Otherwise this
could result in injuries.
When undoing the hose

coupling, hold the hose fi rmly
in your hand, in order to avoid
injuries caused by the hose
springing back.
It is essential that you use

a ¼" threaded barbed
fi tting and quick coupler for
the compressed air connection.
Never put your hands near the

mouth of the device, when the
device is ready for operation.
Otherwise this could result in
injuries.
Before setup or fi rst use, check

the device for any damage. If
the device shows any defects,
then it must not be used under
any circumstances.
Do not use any sharp objects.

Never insert any pointed and/
or metallic objects into the
Safety instructions for the fastening device
inside of the device.
The fastening device powered

by compressed air should only
be connected to lines (pressure
reducer), where there is a
guarantee that exceeding the
maximum permitted pressure by
more than 10% is prevented,
is
10
e.g. through a pressure regu-
lating valve (pressure reducer)
with downstream or integrated
pressure relief valve fi tted in the
compressed air line.
When using fastening devices

powered by compressed air,
make sure that the max. pres-
sure is not exceeded.
The fastening device powered

by compressed air must only
be operated with the pressure
required for that particular
work process, in order to
avoid unnecessarily high
levels of noise, increased wear
and faults which could occur
because of this.
EXPLOSION HAZARD!
Never use hydrogen, oxy-
gen, carbon dioxide or any
other bottled gas as the
source of energy for this
tool, since this may cause
FIRE AND
GB/IE 43