Removing Jammed Staples; Maintenance And Cleaning - Parkside PDT 40 D3 Originalbetriebsanleitung

■ Check whether the fastener is properly driven in
according to requirements.
–
If the fastener protrudes, increase the air
pressure in steps of 0.5 bar.
–
If the fastener is too deep, reduce the air
pressure in steps of 0.5 bar.
■ Alternatively, you can speed up the work, by
holding in the trigger
♦ Apply the compressed air stapler to the work-
piece.
♦ Press the appliance onto the workpiece till the
opening is touching it. The fastener material
leaves the appliance.
♦ As long as you pull the trigger
fastener material leaves appliance each time
the opening touches the workpiece.
♦ Alternatively, you can keep the opening
the appliance permanently pressed onto the
workpiece.
♦ Each time you pull the trigger
leaves the appliance.
NOTE
■ Fine adjustment is also possible with the
knurled screw .
♦ Turn the knurled screw
fastener deeper into the workpiece.
♦ Turn the knurled screw
less deeply into the workpiece.
♦ Turn the exhaust cover
air in the desired direction.
♦ Disconnect the appliance from the compressor
after completing your work.
PDT 40 D3
.
a piece of
of
a fastener
down to sink the
up to sink the fastener
to direct the escaping

Removing jammed staples

If a staple/nail gets stuck in the magazine shaft, im-
mediately remove the compressed air supply line.
♦ Open the magazine
tion "Filling the magazine".
♦ Open the face plate
plate quick release lever
the trigger lock .
♦ Remove the food.
♦ Close the face plate
plate quick release lever
the exhaust panel
♦ Close the magazine
stapler, as described in the section "Filling the
magazine".

Maintenance and cleaning

WARNING! RISK OF INJURY!
Disconnect the appliance from the
compressed air supply.
WARNING!
► Have the power tool repaired by the Service
Centre or a qualified technician and only
using genuine replacement parts. This will
ensure that the safety of the appliance is
maintained.
CAUTION!
► Any service or repair work over and above
that described in this section may only be
carried out by specialists.
♦ Maintain the compressor tool regularly to
ensure safe operation.
♦ Check bolted connections for a tight fit,
retighten if necessary.
♦ We recommend fitting a pressure reducer with
a water separator and an oiler in front of the
compressed air tool.
♦ If there is increased oil or air discharge, check
the compressed air tool and have it serviced if
necessary.
as described in the sec-
by pulling the face
in the direction of
by pulling the face
in the direction of
.
of the compressed air
GB│MT 41
│
■