Safety Instructions For Disc Sander - Parkside PTSG 140 C2 Originalbetriebsanleitung

GB MT
4) Power tool use and care
a) Do not force the power tool. Use
the correct power tool for your
application. The correct power tool
will do the job better and safer at the
rate for which it was designed.
b) Do not use the power tool if the
switch does not turn it on and
off. Any power tool that cannot be
controlled with the switch is dangerous
and must be repaired.
c) Remove the plug from the wall
socket and/or remove the re-
chargeable battery before you
change the device's settings,
change accessory parts or put
away the power tool. Such preven-
tive safety measures reduce the risk of
starting the power tool accidentaIly.
d) Store idle power tools out of
the reach of children and do not
allow persons unfamiliar with
the power tool or these instruc-
tions to operate the power tool.
Power tools are dangerous in the hands
of untrained users.
e) Look after the power tool and
application tool carefully. Check
for misalignment or binding
of moving parts, breakage of
parts and any other condition
that may affect the power tool's
operation. If damaged, have the
power tool repaired before use.
Many accidents are caused by poorly
maintained power tools.
f) Keep cutting tools sharp and
clean. Properly maintained cutting
tools with sharp cutting edges are less
Iikely to bind and are easier to control.
g) Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking
34
into account the working con-
ditions and the work to be per-
formed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
h) Keep handles and grip surfaces
dry, clean and free from oil and
grease. Slippery handles and grip
surfaces do not permit safe operation
and control over the power tool in unex-
pected situations.
5) Service
a) Have your power tool serviced
by a qualified repair person
using only identical replacement
parts. This will ensure that the safety
of the power tool is maintained.
Safety instructions
for disc sander
Caution! Risk of
injury! Wear personal
protective equipment.
Wear safety goggles, hearing
protection, a dust mask and
gloves.
• When working under dust-prone condi-
tions, ensure ventilation holes are clear.
Disconnect the device from the power
supply prior to cleaning.
• Caution, risk of injury! The sanding
disc will continue to run for a short time
after switching off the machine.
• Never make the warning labels on the
power tool illegible.
• Attach the power tool to a solid,
flat and horizontal surface. If
the power tool is prone to slipping or
wobbling, the bit cannot be guided
smoothly and safely.