Initial Start-Up; Securing The Disc Sanding Device; Mounting / Dismounting; The Sanding Table - Parkside PTSG 140 C2 Originalbetriebsanleitung

GB MT
Warning! During operation, this
electric tool generates an electro-
magnetic field which, under certain
circumstances, may impair the
functionality of active or passive
medical implants. To reduce the risk
of serious or lethal injuries, we rec-
ommend that persons with medical
implants consult their doctor and
the manufacturer of their medical
implant before operating the ma-
chine.

Initial start-up

Avoid unintentional start-
ing. Ensure that the mains plug is
removed before carrying out any
adjustments, maintenance or repair
work.
Before operating the disc sanding device,
you must secure it against tipping.
Securing the disc
B
sanding device
Secure the disc sanding device horizon-

tally ( ) or vertically (
surface.
The enclosed screw clamp (16) must grip
into one of the two receptors (4).

Mounting / dismounting

the sanding table

Dismounting the sanding table:
1. Release the screw (9) underneath the
sanding table (11) using the hexagon
socket wrench enclosed (17).
2. Remove the screw (9) and the washer
(8) and pull the sanding table holder
(10) away from the device.
36

) to the working
Mounting the sanding table:
3. To mount the sanding table (11), push
the sanding table holder (10) back
onto the device.
4. Insert the screw (9) with washer (8) and
tighten.
Ensure the 4 lugs are correctly po-
sitioned (see illustration
wise screw (

Replacing sanding paper

Caution! Risk of injury! Discon-
nect the device from the power sup-
ply to prevent unintentional starting.
To make it easier to replace, first
dismount the sanding table (11)
and holder (10) (see "Dismounting/
mounting the sanding table").
Attaching sanding sheet:
1. Press the sanding sheet (18) evenly
onto the sanding disc (1).
Removing sanding sheet:
2. Remove the sanding sheet (18) from the
sanding disc (1).
Trial run:
Perform a trial run at top speed without a
load for at least 1 minute whenever you
change the sanding paper. Remain outside
the hazard area while doing so.
Setting the sanding
table angle
The angle of the sanding table (11) can be
adjusted continuously between -10° and
+50°.
) other-
9) will not screw in.