Safety Instructions For Disc Sander - Parkside PTSG 140 B2 Originalbetriebsanleitung

unless otherwise indicated in the inst-
ructions.
- Damaged switches must be replaced
at a customer service workshop.
- Do not use power tools if the switch
cannot be turned on and off.
• CAUTION! The use of other bits and
other accessories can result in a risk of
personal injury.
• Have your power tool be re-
paired by a qualiied electrician
- This power tool complies with the
relevant safety regulations. Repairs
may only be performed by a qualiied
electrician, using original spare parts;
otherwise accidents involving the user
may result.
Service:
• Have your power tool repaired
only by qualiied specialists and
only with original spare parts.
This will ensure that the power tool re-
mains safe.
Safety instructions for disc
sander
Caution! Risk of injury! Wear
personal protective
equipment.
Wear safety goggles, hearing
protection, a dust mask and gloves.
• When working under dust-prone condi-
tions, ensure ventilation holes are clear.
Disconnect the device from the power
supply prior to cleaning.
• Caution, risk of injury! The sanding disc
will continue to run for a short time af-
ter switching off the machine.
• Never make the warning labels on the
power tool illegible.
• Attach the power tool to a so-
lid, lat and horizontal surface.
If the power tool is prone to slipping
or wobbling, the bit cannot be guided
smoothly and safely.
• The bit should only be moved
against the workpiece when the
device is turned on. Otherwise
there is a danger of the bit becoming
jammed in the workpiece and the work-
piece rotating with the bit. This can
lead to injuries.
• Switch the power tool off imme-
diately if the bit jams.
The bit jams when:
Das Einsatzwerkzeug blockiert, wenn:
- The power tool is overloaded;
- It becomes stuck in the workpiece
being machined.
• Set the correct speed before st-
arting work.
• After completing your work, do
not touch the sanding disc until
it has cooled down. The bit beco-
mes very hot during use.
• Inspect the cable regularly and
have a damaged cable repaired
only by an authorised customer
service centre. Replace dama-
ged extension cables. This will en-
sure that the power tool remains safe.
• Store the power tool safely
when not in use. The storage
place must be dry and lockable.
This prevents the power tool from being
damaged as a result of being stored or
operated by inexperienced people.
• Never leave the tool before it
has come to a complete stand-
still. Bits still in motion can cause injury.
• Do not use the power tool with
a damaged cable. Do not touch
GB IE
21