Menu: Settings / Pressure - BWT bestaqua 14 Einbau- Und Bedienungsanleitung

EN

3.6.2 Menu: SETTINGS / PRESSURE

Settings for permeate pressure parameters:
The main selection menu appears with "Start"
being activated.
START
St a r t
START
S e t t i n g s
Fig. 11: Main selection menu: "Start", "Settings"
1. Menu level (selection menu "Settings")
GENERAL
PRESSURE
CONDUCTIVITY
WCF SETUP
Fig. 12: Menu Level 1: "Settings"
Perform the general settings of the "Settings / PRESSURE"
selection menu in accordance with Fig. 14.
The recommended target values of all settings
are documented in the form "Form for set values
of BWT bestaqua 14, 18" (see Part 7.1).
2. Menu level (adjustable parameters)
START PRESSURE
STOP PRESSURE
STOP TIME DELAY
Fig. 13: Menu Level 2: "Settings/PRESSURE"
44
1x
device settings
General
Pressure of the permeate (ACTIVE)
Conductivity value (μS/cm)
Permeate output/yield WCF menu
Start pressure (ACTIVE)
Stop pressure
Time delay of the pump