Quick Operation; Display And Control Elements; Standard Factory Settings; Initial Softener Settings / Setting The Time Of Day - BWT bestsoft 4 Einbau- Und Bedienungsanleitung

2 Quick Operation

2.1 Display and control elements

[UP]
[arrow up]
Moves cursor and changes entries

2.2 Standard factory settings

Duration of the step times:
Regeneration time:
Hardness of drinking water / capacity: 300 ppm, 1566 litres for 10 litre model
BWT bestsoft 4 / 11
Display
Operating range
Recharge tonight
Salt alarm
Salt setting - care cubes
Salt setting - block salt

2.3 Initial softener settings / Setting the time of day

On first powering up the softener the digits of the display will flash while the valve rotates to service
position, the valve can be heard moving, this can take a few minutes. On locating service position the
display will prompt the installer to set the time. Start by pressing the [SET/RETURN] key, this will make
the hour digit flash, press the [UP/DOWN] key to adjust to the correct hour, once set, press the [SET/
RETURN] key, this will make the minutes digits flash, use the [UP/DOWN] key to adjust the minutes.
Throughout the settings mode use the [UP/DOWN] keys on the softener display to toggle or adjust set-
tings and use the [SET/RETURN] key to store the setting and move on to the next field in the menu.
f
f
[DOWN]
[arrow down]
Depending on the internal settings of the unit
free input at RECHARGE TONIGHT
Standard
(CC)
UK only
(BS)
upper large display line (Time): current time
Lower line (Capacity Charge): remaining capacity
in %.
[SET/RETURN]
Confirms entries
Yes
UK/EU 1,7 ... 5,0 bar
Yes
No OPTION
UK/EU
[RECHARGE]
[REGENERATION]
Programming recharge tonight
(a few minutes)
UK EU
Yes Yes
1,0 ... 8,0 bar
Yes Yes
OPTION
Yes Yes
Yes No
23