Replacing The Light Bulb; Troubleshooting - LIVARNO LUX LSHB 150 B1 Bedienungsanleitung Und Serviceinformationen

Replacing the light bulb

The circuit must be disconnected during all work on the outdoor
halogen spotlight, even when changing the light bulb! There is
a risk of an electric shock!
Only use halogen light bulbs with R7s J78 base and a
maximum power of 150 watts!
Loosen the screw (1) with a Phillips screwdriver and carefully open the
front pane (10). Press the halogen light bulb into one side of the bulb
fitting in order to then remove it from the other side. Then, press a new
halogen light bulb of the same design (see "Technical data" section) into
one side of the bulb fitting in order to then insert it into the other side.
When doing so, do not handle the halogen light bulb (9) by its glass
body. The bulb should only ever be handled with a cloth. Close the front
pane (10) now and tighten the screw (1) again.
Switch on the circuit again.
Cleaning
The circuit must be disconnected during all work on the outdoor
halogen spotlight, even when cleaning it! There is a risk of an
electric shock!
Ensure that no liquid can penetrate the housing of the outdoor
halogen spotlight. There is a risk of an electric shock.
To clean the outdoor halogen spotlight, use a soft, dry cloth and never use
any solvent or cleaner that would corrode the plastic materials. Use a
slightly damp cloth for more stubborn dirt.

10. Troubleshooting

The light does not switch itself on
 The motion sensor (8) is not aligned correctly. Correct the alignment.
 The halogen light bulb (9) is faulty. Replace it.
 The electrical connection is faulty. Get an authorised electrician to
check the electrical connection.
LIVARNO LUX LSHB 150 B1
English - 67