Residual Risks - Parkside PTSG 140 C2 Originalbetriebsanleitung

GB IE
• The bit should only be moved
against the workpiece when the
device is turned on. Otherwise
there is a danger of the bit becoming
jammed in the workpiece and the work-
piece rotating with the bit. This can
lead to injuries.
• Switch the power tool off imme-
diately if the bit jams.
The bit jams when:
- The power tool is overloaded;
- It becomes stuck in the workpiece be-
ing machined.
• Set the correct speed before
starting work.
• After completing your work, do
not touch the sanding disc until
it has cooled down. The bit be-
comes very hot during use.
• Inspect the cable regularly and
have a damaged cable repaired
only by an authorised customer
service centre. Replace damaged
extension cables. This will ensure
that the power tool remains safe.
• Store the power tool safely
when not in use. The storage
place must be dry and lockable.
This prevents the power tool from being
damaged as a result of being stored or
operated by inexperienced people.
• Never leave the tool before it
has come to a complete stand-
still. Bits still in motion can cause in-
jury.
• Do not use the power tool with
a damaged cable. Do not touch
the damaged cable and pull the
mains plug if the cable is dam-
aged while working. Damaged ca-
bles increase the risk of electric shock.
• Avoid abnormal body postures.
Ensure secure footing and keep your
balance at all times.
22
• To avoid hazards, any replacement of
the plug or the connection line must al-
ways be executed by the manufacturer
of the electric tool or their customer
service.
• Water must be kept away from the
power tool's electrical parts and people
within the working range.
• Caution! Never remove any
loose splinters, chips or jammed
pieces of wood when the sand-
ing disc is still running. Always
switch off the machine before repairing
any faults or removing jammed pieces
of wood - pull the mains plug.
• If the power tool's mains
connection cable is damaged, it
must be replaced with a specially
prepared mains connection
cable, which is available from
the online shop
(www.grizzly-service.eu).

Residual risks

Even if properly operating and handling
this electric tool, some residual risks will
remain. Due to its construction and build,
this electric tool may present the following
hazards:
a) Lung damage, if suitable respiratory
protection is not worn.
b) Hearing damage, if suitable ear protec-
tion is not worn.
c) Damages to health due to
- touching the area of the grinding tool
which was not covered;
- the ejection of pieces from workpiece
or damaged grinding discs.
d) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.