Original Accessories/Auxiliary Equipment; Before First Use; Assembling The Solder Wire Roller Assembly; Feeding/Changing The Solder Wire - Parkside PLPD 60 A1 Originalbetriebsanleitung

Original accessories/auxiliary
GB
equipment
IE
NI
Use only the additional equipment and
accessories specified in the operating
instructions. Using attachments or
accessory tools other than those
recommended in the operating
instructions can lead to a risk of injury.

Before First Use

Assembling the solder wire roller
assembly (Fig. 1, 3, 4 )
Insert the roller frame(12) opening into
●
the groove on the back of main body(6)
Push the roller frame(12) down to hear a
●
'click'
Make sure the limiting bump engage into
●
the plastic slot.
Feeding/changing the solder
wire (Fig. 1, 5)
Feeding the solder wire
Unplug the device.
●
Unpack the solder wire (8) from the solder
●
wire roller (10).
Use one hand to insert the solder wire
●
(8) into the solder wire guide cone(13)
and another hand to keep squeezing /
releasing wire feeding trigger(5) until the
solder wire(8) get into the wire feeding
system.
Free one hand and keep squeezing /
●
releasing wire feeding trigger(5) until the
solder wire (8) come out from the solder
wire guide tube(4).
22
Note
►
The solder wire (8) could only go
forward to protect the internal solder
wire feeding system, use plier to cut off
the extra solder wire(8) or pull out the
last solder wire after the feeding system.

Change the solder wire

Unplug the device
●
For short solder wire change
●
cut off solder wire (8) on the back and
remove the solder wire (8) from solder
wire roller (10) and solder wire guide
tube (4)
Wind new solder wire (8) on solder
wire roller (10) and feed solder
wire(8) for operation.
For complete solder wire roller change
●
Unscrew and remove shaft fixing
screw (11)
Remove old solder wire roller (10) and
roller shaft (9) from roller frame (12)
Put new solder wire roller (10) and
roller shaft (9) into roller frame (12)
Insert shaft fixing screw (11) and
tighten
Feed solder wire (8) for operation.
LED indicator (Fig. 1)
LED indicator (7) will light in RED to
●
indicate "HEATING' when plugging in
and the temperature adjustment knob was
not on '0' position.
LED indicator (7) will turn to GREEN to
●
indicate 'READY'when the solder iron
reaches the setting temperature.
Please note: By design, the built-in sensor
●
can only measure the temperature of
the heating element. Consequently,
the soldering tip will reach the target
temperature after a certain delay. When