Preparing For First Use; Mount The Coil Spring; Insert / Replace The Soldering Tip; First Use - Parkside PLS 48 D2 Gebrauchanleitung

Preparing for first use

Mount the coil spring

Insert the clip of the coil spring
„
of the soldering station that is provided for this purpose (see foldout
page) .

Insert / replace the soldering tip

CAUTION! RISK OF BURNS!
Never heat the soldering iron
f
The soldering tip may only be removed with the device switched off and
„
with the soldering tip cooled down .
The soldering tip has a screw thread and can therefore be replaced
„
quickly and easily on the soldering iron .
To remove, turn the soldering tip anti-clockwise .

To secure, turn the soldering tip clockwise .


First use

Switching on / off and setting the temperature

Switch on and set the temperature
Connect the plug into a suitable mains socket and press the ON / OFF
r
switch into the position "I" . Turn the temperature regulator
desired temperature .
NOTE
Before use, remove the protective cap from the soldering tip
f
24
| GB
as far as it will go into the recess
u
n
without soldering tips
t
.
q
and set the
.
t
PLS 48 D2