Original Accessories / Attachments; Before First Use; Inserting / Replacing Soldering Tips - Parkside PLS 48 A1 Bedienungs- Und Sicherheitshinweise

Original accessories / attachments

Q
J
Use only the accessories detailed in the operating instructions. The
use of attachments or accessories other than those recommended
here could lead to you suffering an injury.

Before first use

Q

Inserting / replacing soldering tips

Q
CAUTION! DANgER OF BURNS! Allow the soldering
pencil to heat up without a soldering tip.
J
Remove a soldering tip only when the device has been switched
off and the soldering tip has cooled.
j
Turn the soldering tip out to replace it.
You must 'tin', i.e. thinly coat with solder, the soldering tip
using the soldering station for the first time and before using a new
soldering tip.
To do this follow these steps:
j
Insert the mains plug into a mains socket and press the ON / OFF
switch into position "I".
2
j
Turn the temperature regulator
flow and deposit a thin continuous film over the surface of the sol-
dering tip.
Safety advice / Before first use
to 2 and allow a little solder to
6
before
7
GB 13