Parkside PLSD 48 B2 Gebrauchsanleitung Seite 18

carried out by children without supervision.
•If the mains supply cable of this device gets damaged, it must
be replaced by the manufacturer or its customer service or by
a similarly qualified person in order to avoid hazards.
ATTENTION! DANGER OF ELECTRIC
SHOCK! Do not use the digital soldering
station if the handle, power cable
or plug is damaged. Never open
the device!
•RISK OF BURNS! Before using, check that the tool tip is
properly attached to the device. Never touch the
heated soldering tip or the molten solder. There is a risk
of burns. The device must be allowed to cool down before
changing, cleaning or checking any components. The hot tool
tip and its mounting must not come into contact with skin,
hair, etc. Risk of burns.
•After working, allow the soldering iron to cool down only in
the air. Under no circumstances quench with water!
•BEWARE! DANGER OF FIRE! Only use the holder (2) for
putting down the hot soldering iron.
•During work breaks, the soldering iron must be placed in the
holder (2) and the device must be disconnected from
the power source.
•Keep the device away from inflammable material.
•Do not apply excessive pressure to the tips during use. When
pressure is applied, the thin tips may bend.
•A fire can be started if the device is not carefully handled.
•Never leave the device unattended when switched on.
•BEWARE! RISK OF INJURY! Keep your hands away from the
heated workpiece. Heat can be released through the
workpiece.
•DO not let the hot soldering tip touch the plastic parts of the
holder (2). Otherwise this may result in damage to the device.
•In case of danger, immediately remove the plug from the mains socket.
PLSD 48 B2
GB |
15