Mounting The Compressed Air Hose; Operation; Inflation - Parkside PALP 20-Li B2 Originalbetriebsanleitung

on/off switch (10) needs to be pres-
sed twice.
Switching off the cordless
compressor
1. Press the On/off switch (10)
once.
2. Press and hold the On/off button
(6) for 3 seconds.
The display (4) goes out. The
preconfigured pressure is saved.
The devices are not suitable for
long-term use. Operation for over
20 minutes can cause overheating
and damage to the devices. If the
device is overloaded, switch it off
immediately and only put it back
into operation when it has cooled
down.
Mounting the
compressed air hose
(only the cordless compres-
sor)
1. Loosen the coupling nut (1) (not com-
pletely).
2. Insert the device connection (12c) of
the compressed air hose (12) into the
retainer.
3. Retighten the coupling nut (1).

Operation

Inflation

Cordless air pump
1. Remove the valve cap on the
inflatable item.
2. Place the desired valve adapter
(23) on the air exhaust opening
(18) of the cordless air pump.
3. Insert the valve adapter (23) into
the valve on the inflatable item.
4. Turn the device on (On/off
switch (20) to position "I").
5. Switch the device off (On/off
switch (20) to position "0") when
the desired filling volume has
been reached.
6. Remove the valve adapter (23).
7. Put the valve cap of the inflatab-
le item back on.
Cordless compressor
1. Remove the valve cap on the
inflatable item (if applicable).
2. Mount the compressed air hose
(12) (if applicable).
3. Open the locking lever (12a) (if
applicable).
4. Place the desired valve adapter/
ball needle (13/14/15/16) on
the valve connection (12b) of the
compressed air hose (12).
5. Close the locking lever (12a)
again (press towards the com-
pressed air hose).
6. Set the desired pressure on the
display (4) (see "Changing the
pressure setting").
7. Insert the ball needle/valve ad-
apter (13/14/15/16) into the
valve on the inflatable item.
8. Turn the device on (see "Swit-
ching on/off").
9. Press the On/off switch (10).
The LED work light (11) lights
up. When the preconfigured
pressure is reached, the device
switches off automatically.
10. Remove the valve adapter/ball
needle (13/14/15/16).
11. Put the valve cap of the inflatab-
le item back on (if applicable).
GB IE
29