Deflation; Valve Adapter; Working Instructions; Changing The Pressure Setting - Parkside PALP 20-Li B2 Originalbetriebsanleitung

GB IE

Deflation

(only the cordless air pump)
1. Place the appropriate valve adapter
(23) on the air inlet opening (17) of the
cordless air pump.
2. Remove the valve cap of the inflatable
item and insert the valve adapter (23)
into the valve on the inflatable item.
3. Turn the device on (On/off switch (20)
to position "I").
4. Once the inflatable item is entirely
deflated, switch the device off (On/off
switch (20) to position "0").
5. Remove the valve adapter (23).
6. Put the valve cap of the inflatable item
back on.

Valve adapter

Valve adapter
a:
Valve adapter
b:
Valve adapter
c:
Valve adapter
d, f:
Valve adapter
e:
Ball needle::
Valve adapter
for Presta val-
ves:
30
For all standard valves
with an internal diame-
ter from 8 mm.
For inflatable items with
a screw-on valve. Defla-
tion is only possible with
the valve unscrewed
and with adapter b.
For inflatable items with
an exhaust valve.
For inflating air mattres-
ses and the like.
For inflating water balls
and the like.
For inflating different
balls.
For inflating bicycle
tyres.
Valve adapter
For inflating bicycle
for Dunlop/
tyres.
Woods valves:

Working instructions

Changing the pressure
setting
(only the cordless compres-
sor)
1. Switch the display (4) on the cordless
compressor on (see "Switching on/
off").
2. Press the "+" button (7) on the display
(4) to increase the pressure setting.
Press and hold the "+" button (7) for
approx. 3 seconds. The numbers on
the display (4) begin to flash. You can
now increase the preset value by pres-
sing the "+" button (7). The number is
increased by 0.1 bar / 1 PSI each time
you press.
3. To decrease the preset value, proceed
in the same way but using the "-" but-
ton (5).
By briefly pressing the On/off
button (6) on the display, you can
switch the display of the pressu-
re unit between "bar" and "psi"
(pounds per square inch). The
display (4) has to be on (see "Swit-
ching on/off").

Cleaning and Servicing

Switch off the device and
remove the battery before
carrying out any maintenan-
ce work.