Vacuum Cleaning; Using The Accessories - Silvercrest SHAZB 29.6 B2 Bedienungsanleitung

8. Vacuum cleaning

CAUTION:
During vacuuming, all filters and the
dust container 8 must be assembled at
all times.
1. Assemble the accessories needed.
2. Insert the battery 29 into the battery
compartment 7.
3. Press the on/off switch
the device on.
- If you want to reduce the suction pow-
er, press the ECO 22 button once.
The LED under the button will be lit
green. To switch off the function, press
the button again.
4. When the dust container 8 is full to the
marking MAX, stop vacuuming and
empty the dust container 8.
5. To switch off the suction device 2, press
the on/off switch
6. Empty the dust container 8 and hang up
the parts back in the base station 26.
NOTES:
• After switching on, it takes 1 - 2 seconds
before the device can be switched off
again.
• When using the floorhead 35, the LEDs
of the LED bar 39 are automatically
switched on. This allows you to see the
area to be vacuumed at all times, even
in dark corners.
• After switching on, it takes 1 - 2 seconds
before the device can be switched to the
mode with reduced suction power using the
ECO 22 button.
• If the rotating brush 37 / hard floor roll-
er 40 is blocked, the vacuum cleaner
switches off. The LEDs 21 / 28 / 39
flash for approx. 7 seconds. Only then
can the vacuum cleaner be switched on
again.
32 GB
1 to switch
1 again.

Using the accessories

In the following table, you will find an over-
view of the cleaning tasks for which the var-
ious accessories are particularly suitable.
No. Nozzle
Floorhead
35
with rotating
+ 37
brush
Floorhead
35
with hard floor
+ 40
roller
Brush nozzle
43
Crevice noz-
44
zle
Use
Versatile use for
cleaning floors
For cleaning hard
floors (e.g. tiles,
laminate)
Sofas, armchairs,
mattresses, furni-
ture, textiles, book
shelves
Cabinets, crevices,
corners, gaps