Operation; Vacuum Cleaning - Silvercrest SMZS 1600 A1 Bedienungs- Und Sicherheitshinweise

3 Operation

3.1 Vacuum cleaning

3 Operation
13
14
66
WARNING:
Danger of injury! A damaged appliance must never be
used. Check the vacuum cleaner and the power cord
each time before using it.
WARNING:
Danger of injury! Especially when vacuum-cleaning stairs
make sure that you always stand on a higher level than
the appliance.
ATTENTION:
Only use the cylinder vacuum cleaner when all filters are
intact, dry and correctly fitted. Make sure that no open-
ings are clogged. Otherwise the vacuum cleaner might
be damaged.
ATTENTION:
Check the requirements of your floorings before using
the vacuum cleaner. Follow the recommendations of the
flooring manufacturers.
1. Attach the desired nozzle ZChapter 2.2, "Assembly" or
ZChapter 2.3, "Using further nozzles (accessories)".
2. Pull out the power cord until the yellow marking is visible
(Fig. 13/1).
WARNING:
Danger of electric shock! If the red marking shows
(Fig. 13/2) retract the cord by pressing the retract button
to pull in the cable (Fig. 14/2) up to the yellow mark
again. Otherwise the cable can break off.
3. Insert the mains plug into a socket with ground/safety
contact.
4. Switch on the cylinder vacuum cleaner with the on/off
switch (Fig. 14/1). The green indicator light is on.