Changing The Roller In The Floorhead; Prior To Every Use; Filter Unit - Silvercrest SHAZB 29.6 B2 Bedienungsanleitung

7.3 Changing the roller in
the floorhead
You can replace the rotating brush 37 in-
side the floorhead 35 with the hard floor
roller 40.
1. Turn the floorhead 35 upside down.
2. Pull the small button outwards towards
the open lock symbol and remove the
small cover.
3. Remove the rotating brush 37 from the
floorhead 35.
4. Instead of the rotating brush 37, insert
the hard floor roller 40 into the floor-
head 35.
5. Replace the small cover. Pull the small
button outwards towards the open lock
symbol while closing the small cover.
6. Let go of the small button again. It
points to the closed lock symbol.
7. You can swap the rotating brush 37
and the hard floor roller 40 back again
in the same manner.
7.4

Prior to every use

Prior to every use, the following parts must
be assembled:

Filter unit

15
13
12
10
8
Dust container
8 2
Battery
7 29
• To remove the battery 29 from the bat-
tery compartment 7, press in both un-
locking buttons 6 of the battery and pull
the battery out.
The filter unit consists of:
the motor protection fil-
ter 15, the paper fil-
ter 13 and the filter
carrier 12 with the met-
al filter 10.
• Always insert the
complete filter unit
into the dust contain-
er 8.
Only use the dust con-
tainer 8 with the com-
plete filter unit.
• Place the dust con-
tainer 8 onto the suc-
tion device 2
(see "Assembling the
dust container" on
page 33) from be-
low.
The vacuum cleaner can-
not be operated unless
the battery 29 is assem-
bled and charged.
• Insert the battery 29
into the battery com-
partment 7 until it en-
gages audibly.
GB
31