Changing / Cleaning The Hepa Filter; Cleaning The Vacuum Cleaner; Troubleshooting / Problem Solving; Disposal - Silvercrest SBSB 750 A1 Bedienungs- Und Sicherheitshinweise

Close the lid of the dust bag compartment until
it clicks into place audibly.
Changing / cleaning
the HEPA filter
Note: Clean the HEPA filter
on how frequently the product is used, it is recom-
mended that the HEPA filter
6-9 months.
Remove the lid of the HEPA filter
on the lever (see Fig. H).
22
Remove the HEPA filter
To clean the HEPA filter
If the HEPA filter
21
it with lukewarm, soapy water. If you do this,
leave the HEPA filter
it using artificial means.
Insert the HEPA filter
inserting it, make sure that the rough side is
visible.
Before using the product, make sure that the
HEPA filter is installed correctly.
21
Close the lid of the HEPA filter

Cleaning the vacuum cleaner

Unplug the mains plug from the mains socket
before cleaning.
Allow the vacuum cleaner
fully.
Wipe down the vacuum cleaner
slightly damp cloth. Then allow all parts to dry
completely.
Clean the suction nozzles and remove any dust
and dirt.
Troubleshooting /
Problem solving
Note: The product has a temperature switch that
protects the motor against overheating. If the product
suddenly switches itself off, proceed as follows:
regularly. Depending
21
is changed every
21
by pressing
21
.
21
, shake it vigorously.
21
is very dirty, you may clean
to air dry. Do not dry
21
back into its slot. When
21
.
21
to cool down
1
using a
1
Switch off the product by pressing on the foot
pedal .
14
Unplug the mains plug from the mains socket.
Determine the cause of the overheating. It may
have been caused by the following: a clogged
hose , clogged dust bag or dirty HEPA filter
2
.
21
Clean the hose and the dust bag. Also clean
2
the HEPA filter .
21
Wait for around 30–40 minutes, until the motor
has cooled down.
Plug the mains plug into the mains socket and
switch the product on by pressing on the foot
pedal .
14
If the product still does not work, switch it off
again using the foot pedal
further 20 minutes. Then switch the product on
again using the foot pedal
If the product is still not functioning, contact
customer services (see ‚Service centre' section).

Disposal

The packaging is made entirely of recyclable
materials, which you may dispose of at local
recycling facilities.
Observe the marking of the packaging
materials for waste separation, which
b
a
are marked with abbreviations (a) and
numbers (b) with following meaning: 1–7:
plastics / 20–22: paper and fibreboard /
80–98: composite materials.
The product and packaging materials
are recyclable, dispose of it separately
for better waste treatment. The Triman
logo is valid in France only.
Contact your local refuse disposal
authority for more details of how to
dispose of your worn-out product.
To help protect the environment, please
dispose of the product properly when it
has reached the end of its useful life and
and wait for a
14
.
14
GB/MT 37