Dust Container And Filters; Assembling The Dust Container; Emptying The Dust Container; Paper Filter (Hepa) - Silvercrest SHAZB 29.6 B2 Bedienungsanleitung

9. Dust container and
filters
CAUTION:
During vacuuming, all filters and the
dust container 8 must be assembled at
all times.
Every operation requires the dust contain-
er 8 and all filters to be inserted:
- the metal filter 10 inside the dust
container 8,
- the paper filter 13 inside the filter carri-
er 12,
- the motor protection filter 15 on the pa-
per filter 13,
- the exhaust air filter 18 at the top of the
suction device 2.
9.1 Assembling the dust
container
9
8
• To remove, turn the dust container 8 an-
ticlockwise and then pull it off down-
wards.
• Place the dust con-
tainer 8 onto the suc-
tion device 2 in such
a way that the arrow
above the open pad-
lock symbol points to
the 9 marking.
• Turn the dust contain-
er 8 clockwise until it
clicks into place.
Now the arrow
above the closed
padlock symbol
points to the 9
marking.
9.2 Emptying the dust
container
14
11
• To lock the flap 11, close it again until it
audibly clicks into place.
9.3

Paper filter (HEPA)

The paper filter 13 sits inside the filter carri-
er 12.
• Remove the paper filter 13 by pulling it
out upwards using the small handle in
the middle.
13
12
• To empty the dust
container 8, you do
not need to remove it
from the suction de-
vice 2.
• Hold the suction de-
vice above a waste
container and then
press the button 14
to open the flap 11
at the bottom of the
dust container 8.
• To insert, place the
paper filter 13 into
the filter carrier 12
from above.
GB
33