Base Station; Fastening The Base Station; Storing And Charging In The Base Station - Silvercrest SHAZB 29.6 B2 Bedienungsanleitung

5. Base station

5.1 Fastening the base
station
Fasten the base station 26 to the wall using
the drilling template and the fixing material
included in the delivery.
NOTE: before fastening, check that the fix-
ing material included in the delivery meets
your requirements (e.g. wall structure). If not,
replace it with suitable fixing material.
1. Look for a place on the wall for the base
station 26. Make sure that there is a
wall socket nearby.
2. Using the drilling template, draw the
marking for the drill holes on the wall.
3. Drill holes with a diameter of 6 mm us-
ing a drill.
4. Insert the rawlplugs into the drill holes.
5. Tighten the screws in the rawlplugs.
6. Hang the base station 26 up on the
wall and check for a secure hold.
28 GB
5.2
The base station 26 is used as a holder and
battery charger for the suction device 2 with
the suction pipe 32, the brush nozzle 43
and the crevice nozzle 44. After every use,
hang the suction device 2 up in the base sta-
tion 26.
26
Storing and charging in
the base station
23
26
27
26
27
2
32
• Hang the suction de-
vice 2 with the re-
cess between the
charging contacts 5
on the hook 23 of the
base station 26.
• The battery 29 will
be charged automati-
cally.
• The suction pipe 32
remains attached to
the suction device 2.
• The crevice nozzle 44
and the brush noz-
zle 43 can be
plugged onto the
holders 27.
• The floorhead 35
can stay connected to
the suction pipe 32.