Cleaning The Condenser - Gastrodomus GRANISMART 1 BRS Betriebsanleitung

• remove the used battery and fi t a new one in its place, taking care to comply
with the polarities indicated;
Fig.71
• Close the cover of the battery compartment.
Note: the cover must be closed by hand; should you encounter
any diffi culty in closing the cover, check whether the battery
has been correctly positioned.
Cautionary notes:
• Do not insert a used battery or one of a different type;
• If the machine will remain unused for a long period, remove the battery
from its compartment and store it in a suitable place;
• In normal conditions of use, a new battery will have a life of about one
year;
• Spent batteries must be disposed of in accordance with the laws in the
user's country.

7.10. Cleaning the condenser

The condenser may be cleaned solely by a specialized techni-
cian, who must organize all of the operational sequences and
use suitable equipment, in strict compliance with the applica-
ble regulations currently in force.
Periodically clean the condenser situated inside the machine.
Warning: before proceeding to clean the condenser, switch off
and unplug the machine.
Warning: When safety guards are removed, you have access to
some sharp surfaces of the machine.
A dirty condenser will impair the performance of the machine.
To access the condenser remove the safety guards.
It is forbidden to use the machine when even only one panel
(front, rear or side) is not set properly in place. It is prohibited
for the operator to clean the condenser.
SL320000819 Ed.12 - 07-2013
7.10.1. Cleaning the cond. of a 1-bowl Granita machine
The guards must be removed using a suitable screwdriver.
CONFIGURATION 1
Remove the side safety guards, taking out the screws securing them to the
machine.
Fig.72
Remove the rear guard after taking out the screws securing it to the frame (the
screws are situated on the left and right sides).
Fig.73
After removing the guard, use a dry brush to remove the dust that has built up
over time with use.
Fig.74
After thoroughly cleaning the condenser, fi t all the guards back in place.
- 23_EN -