Safety Precautions - PeakTech 1020 A Bedienungsanleitung

Safety precautions

This product complies with the requirements of the following directives of
the European Union for CE conformity: 2014/30/EU (electromagnetic
compatibility), 2014/35/EU (low voltage), 2011/65/EU (RoHS).
Overvoltage category IV 600V; pollution degree 2.
CAT I: For signal level, telecommunication, electronic with small
transient over voltage
CAT II: For local level, appliances, main wall outlets, portable
equipment
CAT III: Supplied from a cable under earth; fixed installed switches,
automatic cut-off or main plugs.
CAT IV: Units and installations, which are supplied over aerial line,
which are stand in a risk of persuade of a lightning, i.e. main-
switches on current input, overvoltage-diverter, current use
counter.
To ensure safe operation of the equipment and eliminate the danger of
serious injury due to short-circuits (arcing), the following safety precautions
must be observed.
General:

Read these operating instructions carefully and make them
available to subsequent users.

It is essential to observe the warning notices on the device, do not
cover or remove them.

Pay attention to the use of the device and only use it in the suitable
overvoltage category.

Familiarize yourself with the functions of the measuring device and
its accessories before you carry out the first measurement.

Do not operate the measuring device unsupervised or only
protected against unauthorized access.
19