PeakTech 1020 A Bedienungsanleitung Seite 21

Measurement environment:

Avoid any proximity to explosive and flammable substances, gases
and dust. An electric spark could lead to an explosion or
deflagration - danger to life!

Do not carry out measurements in corrosive environments, the
device could be damaged or contact points inside and outside the
device could corrode.

Avoid working in environments with high interference frequencies,
high-energy circuits or strong magnetic fields, as these can
negatively affect the device.

Avoid storage and use in extremely cold, humid or hot
environments, as well as long-term exposure to direct sunlight.

Only use devices in damp or dusty environments in accordance
with their IP protection class.

If no IP protection class is specified, only use the device in dust-free
and dry indoor rooms only.

When working in damp or outside areas, pay particular attention to
completely dry handles on the test leads and test probes.

Before starting the measuring operation, the device should be
stabilized at the ambient temperature (important when transporting
from cold to warm rooms and vice versa)
Maintenance and Care:

Never use the device if it is not completely closed.

Before each use, check the device and its accessories for damage
to the insulation, cracks, kinks and breaks. If in doubt, do not take
any measurements.

Change the battery when a battery symbol is displayed to avoid
incorrect readings.

Switch off the device before changing batteries or fuses and also
remove all test leads and temperature probes.

Replace defective fuses only with a fuse that corresponds to the
original value. Never short-circuit a fuse or fuse holder.
21