Starting Up; First-Time Operation - Bosch Rexroth LG 2/H Montageanleitung

8 Starting up

8.1 First-time operation

Unforeseen movements, falling workpiece carrier
Injury caused by falling objects.

Make sure that the product has been installed correctly by qualifi ed personnel
(see page 8) before starting it up.
Unforeseen movement, falling Liftgate
Injuries due to falling Liftgate.

Guide the Liftgate by the handles throughout the entire opening or closing
process.
Malfunctions due to incorrect installation and startup
The product can be damaged; the service life may be adversely affected.

Starting up requires basic mechanical, pneumatic and electrical knowledge.

The product may only be operated by qualifi ed personnel (see page 8).
• Before fi rst use or re-commissioning, check that the Liftgate is operating safely,
especially the force feedback that occurs during opening and closing.
• Before fi rst use or re-commissioning of a conveyor system, run a risk assessment in
accordance with DIN EN ISO 12100.
• According to EU Machinery Directive 2006/42/EC, you must equip the transfer
system with EMERGENCY STOP devices.
• The surfaces of engines and gearboxes can reach temperatures of over 65 °C under
certain load and operating conditions. In these cases, you must comply with the
appropriate design measures (protective measures) or the corresponding warnings
of the applicable accident prevention regulations (UVV)!
• Make sure that all electrical and pneumatic connections are in use or closed.
Check that all screws and plugs are securely fastened. All relevant protective covers
must be installed.
• Continuous conveyors which are in motion or in operation may only be inspected
and adjusted once all required safeguards are in place.
• Note EN ISO 13857 when you remove or replace safeguards and / or nullify a safety
guideline.
• Test runs with open panels are only allowed if they are carried out by a competent
person using tip switches and no interference through other switching elements
exists.
• Only start up the product when all safety devices of the system are installed and
are operational.
• Only start up a fully assembled product.
CAUTION
NOTICE
3 842 358 734/2015-01, MIT: Liftgate, Bosch Rexroth AG
Starting up 35/44