Designations; Safety Instructions; About This Chapter; Intended Use - Bosch Rexroth LG 2/H Montageanleitung

1.3.3

Designations

In this documentation, the following designations are used:
Table 4: Designations
Designation Meaning
LG 2/H Mounting kit Liftgate
BS 2/... Conveyor belt from the Rexroth transfer system TS 2plus
SZ 2 Belt support from the Rexroth transfer system TS 2plus
WT 2 Workpiece carrier from the Rexroth transfer system TS 2plus

2 Safety instructions

2.1 About this chapter

The product was manufactured in accordance with generally accepted engineering
standards. Nevertheless, there is a risk of personal injury and property damage if you
do not observe this chapter and the safety instructions in this document.

Read this manual thoroughly and completely before you start working with the
product.

Keep the documentation accessible to all users at all times.

When passing on the product to a third party, make sure that it is always
accompanied by the necessary documentation.

2.2 Intended use

The product is an incomplete machine.
You may use the product as follows:
• For installation in a Rexroth TS 2plus transfer system, in conjunction with a
BS 2 / ... conveyor belt and SZ 2 belt support.
• For the maximum load / line load see Technical data on page 43.
• For the environmental conditions see page 43.
The product is strictly intended for professional use and not for private use.
The intended use also implies that you have read and understood this
documentation, especially chapter 2 "Safety".
Safety instructions
3 842 358 734/2015-01, MIT: Liftgate, Bosch Rexroth AG
7/44