Torch Care; Technical Data - LORCH S Pulse XT Bedienungsanleitung

Technical data

 Remove the ventilation grill from the front panel.
 Remove the screw attaching the ventilation grill to the
bottom panel.
20 Technical data
Machine type
Welding
Welding range (I2min - I2max/U2min - U2max) A/V
No-load voltage
Power consumption in idle mode
Voltage setting
Slope characteristic
Welding current at ED 100 % 40°C
Welding current at ED 60 % 40°C
ED at max. welding current 40°C
Weldable wires steel
Weldable wires aluminium
Weldable wires CuSi
01.21
 Remove the ventilation grill from the bottom panel.
 Check both dust filters for dirt.
 Replace the dust filters if dirty
Check the filling level of the cooling liquid each time be-
fore use (see„12.8 Topping up the cooling liquid" on Page
46).
19.2
 Remove the weld spatter from inside the gas nozzle using
 Spray the inside surface of the gas nozzle with a releasing
9 This will prevent weld spatter from being burnt on.
S3 mobile
25 - 320/
15.2 - 30
V 78 - 109
W 28,5
A 250
A 280
% 40
Ø mm 0.6 - 1.2
Ø mm 1.0 - 1.2
Ø mm 0.8 - 1.2
909.2599.9-06
Order number for filter matting see ET list.
Never make repairs or technical changes
yourself.
In this case, the manufacturer's warranty is no
longer valid and the manufacturer accepts no
product liability for the equipment.
If you experience problems or need repairs,
i i
contact a dealer authorised by Lorch.

Torch care

suitable tongs.
agent, or use nozzle protection paste.
S3
25 - 320/ 25 - 400/
15.2 - 30 15.2 - 34
79 - 113 79 - 113
28,5 28,5
Infinitely variable
constant/downwards
250 320
280 350
40 50
0.6 - 1.2 0.6 - 1.6
1.0 - 1.2 1.0 - 1.6
0.8 - 1.2 0.8 - 1.2
S5 S8
25 - 500/
15.2 - 39
72 - 96
48,3
400
500
60
0.6 - 1.6
1.0 - 2.4
0.8 - 1.2
- 63 -