Mounting The Magnetic Tape - Siko MSA213C Originalmontageanleitung

MSA213C
Installation

4.2 Mounting the magnetic tape

Solving bonding of the magnetic tape
NOTICE
` Remove foreign anti-adhesive substances including oil, grease or dust
` For optimum bonding, the surfaces to be bonded must be dry and
` Observe a bonding temperature between 20 °C and 30 °C in dry rooms.
Deterioration of measuring accuracy
NOTICE
` Mount magnetic tape level with the mounting surface or distance to
Length of the magnetic tape
NOTICE
` For technical reasons, the magnetic tape must be ≥64 mm longer than
Fig. 1: Magnetic tape length
When applying long pieces of magnetic tape do not immediately remove
the complete protective film, but rather peel back a short part from the
end sufficient to fix the tape. Now align the tape. As the protective tape is
then peeled back and out press the tape firmly onto the mounting surface.
A wall paper roller wheel could be used to assist in applying pressure onto
the magnetic tape when fixing it in position.
Mounting
1. Clean mounting surface
2. Remove protective film
3. Stick down the magnetic tape
4. Clean surface of magnetic tape carefully.
5. Remove protective film
6. Fix cover tape (both ends should slightly overlap).
7. Also fix cover tape's ends to avoid unintentional peeling.
MSA213C · Date 19.04.2021 · Art. No. 89792 · Mod. status 340/18
by means of detergents that are preferably evaporating residue-free.
Suitable detergents include ketones (acetone) or alcohol offered for
instance as fast cleaning agents by the Loctite or 3M companies.
bonding shall be carried out with maximum contact pressure.
be measured. Unevenness deteriorates measuring accuracy.
the distance to be measured.
1
2
5
(Fig. 2):
54 5
carefully.
1
of the adhesive tape
2
.
4
of the cover tape
6 5
English
Required tape
1
length = measuring
section + 64 mm
(min. 200 mm)
Measuring section
2
.
3
.
19