Remote Control Battery Installation - Clatronic ar 773 Bedienungsanleitung

Important Information
for installing your carradio!
1. The screws (h) of the transport locking device should
be removed before installation, as otherwise the CD
cannot be inserted.
2. The device is designed for the minus pole of the battery,
which must be connected to the body of the vehicle. Please
check this before installation.
3. When installing/connecting your device please note that not
every vehicle is equipped with an "ISO connection". In this
case we recommend the use of an ISO adapter specifi cally
designed for your vehicle.
Adapters are available from car accessory shops and/or
from your vehicle workshop.
4. Depending on the specifi c car type, different wiring connec-
tion of the „Duration +" wire (Constant current connection)
are available. (However, this is necessary for storing the
radio stations).
In order to guarantee all functions, installation in line with
these instructions is essential. In cases of doubt please
contact an authorised car workshop.
Due to the large number of vehicle types and manufac-
turers the correct confi guration of the ISO plug cannot be
guaranteed, even if the ISO plug connections fi t together
mechanically. It may therefore be necessary to change the
electricity connection or use adapters made specifi cally for
motor vehicles.
NOTE:
When connected correctly, the radio can be switched on
and off by means of the ignition. If the stored stations are
lost the radio does not receive any „Permanent +" required
for station storage.
CAUTION:
If the connection is made to „Permanent +" without ignition
the car radio may be subjected to a load even with the
ignition switched off. In the worst case this may result in
the car battery becoming completely discharged.
In the case of car radios with Bluetooth it is essential that
the connection is made properly via the ignition. Otherwise
there will be no correct separation of the radio connection
between the car radio and the mobile telephone.
5. The angle of inclination when a car radio is installed must
not exceed 20°, as in the case of greater angles of inclina-
tion the function of the car radio (CD/DVD Player) can no
longer be guaranteed.
6. Depending on the specifi c car type, interferences can
be possibly arise during radio/CD/DVD operation. These
interferences can avoided easily with an additional Inter-
ferences fi lter. Your car radio is originally prepared with an
Interference Filter already.
In these case, please contact your authorized car dealer.
30
05-AR 773 DVD_GB.indd Abs1:30 05-AR 773 DVD_GB.indd Abs1:30
7. When installing your radio please ensure that there is
enough space at the rear of the radio to ensure suffi cient
cooling.
8. For the antenna connection there are two different norms.
The fi rst of these is the old (50 ohm) version with a long
protruding round contact on the vehicle and a round socket
on the radio end. The second is the ISO-standardised
antenna plug (150 ohm). Adapters for both formats are
available from accessory manufacturers and/or your car
workshop.
Important information for VW/Audi vehicles: The active
antenna requires voltage on the shielding of the antenna
coaxial cable, without which reception is unsatisfactory. An
antenna adapter with phantom power supply will solve this
problem.
Operating Instructions
1. If the front control panel is removed while the radio or CD is
on, the device is automatically switched off.
2. Any errors (ERROR) occurring during operation can be
corrected by pressing the RESET button. Use a piece of
wire or similar item to press the RESET button (4) in order to
return the electronics to its original state.
3. If the interior of the vehicle becomes very hot, for example
after standing in direct sunlight for a prolonged period, do
not switch on the player until the inside of the vehicle has
cooled down a little after you have been driving for a few
minutes.
4. In order to keep the removable control panel in a safe place
you should always use the protective case provided.
5. Playback of CDs/DVDs produced by the user cannot be
guaranteed due to the large variety of software and CD/DVD
media available.
6. Some keys are to be found both on the device itself and on
the remote control. Keys with the same designation have the
same function.
7. Flashing LED (not shown)
When the front control panel is removed this display fl ashes.
Starting up

Remote control battery installation

WARNING:
Leaking out battery acid can damage your health. Remove
the battery from the battery compartment as soon as it is
exhausted or if the remote control is not going to be used for
a longer period of time. Wipe up leaked out battery acid with
a cloth. In case of skin contact immediately wash the affected
area. Seek medical advice if battery acid has been swallowed.
In case of contact with your eyes wash out the eyes and seek
medical advice.
19.10.2007 14:14:42 Uhr 19.10.2007 14:14:42 Uhr