Installation; Take Out Screw Before Installation; Din Front-Mount (Method A); Installing The Unit - Clatronic AR 819 BT/USB/Card Benutzerhandbuch

INSTALLATION

Notes:
Choose the mounting location where
the unit will not interfere with the normal
driving function of the driver.
Before finally installing the unit, connect
the wiring temporarily and make sure it
is all connected up properly and the
unit and the system work properly.
Use only the parts included with the
unit to ensure proper installation. The
use of unauthorized parts can cause
malfunctions.
Consult with your nearest dealer if
installation requires the drilling of holes
or other modifications of the vehicle.
Install the unit where it does not get in
the driver's way and cannot injure the
passenger if there is a sudden stop, like
an emergency stop.
Avoid installing the unit where it would
be subject to high temperature, such as
from direct sunlight, or from hot air,
from the heater, or where it would be
subject to dust, dirt or excessive
vibration.
DIN FRONT/REAR-MOUNT
This unit can be properly installed either
from "Front" (conventional DIN Front-mount)
or "Rear" (DIN Rear-mount installation,
utilizing threaded screw holes at the sides
of the unit chassis). For details, refer to the
following illustrated installation methods.

TAKE OUT SCREW BEFORE INSTALLATION

Before install the unit, please remove the
two screws.
Take out screw
before installation.
All manuals and user guides at all-guides.com

DIN FRONT-MOUNT (Method A)

Installation Opening
This unit can be installed in any dashboard
having an opening as shown below:

Installing the unit

Be sure you test all connections first, and
then follow these steps to install the unit.
1. Make sure the ignition is turned off, and
2. Disconnect the wire harness and the
3. Press the release button on the front
4. Lift the top of the outer trim ring then pull
5. The two supplied keys release tabs
Outer Trim Ring
Front Panel
26
182mm
then disconnect the cable from the
vehicle battery's negative (-) terminal.
antenna.
panel and remove the control panel
(see the steps of "removing the front
panel").
it out to remove it.
inside the unit's sleeve so you can
remove it. Insert the keys as far as they
will go (with the notches facing up) into
the appropriate slots at the middle left
and right sides of the unit. Then slide
the sleeve off the back of the unit.
Sleeve
L Key
R Key
53mm