Clatronic ar 773 Bedienungsanleitung Seite 31

CAUTION:
When disposing of old batteries you should strictly comply
with the legal and environmental regulations applicable in your
country. Do not throw batteries into fi re!
NOTE:
The lifetime of the enclosed battery may be shortened
because of storage.
NOTE:
The lithium cell in the battery compartment of the remote
control has been secured for transport with a foil. Before initial
use please remove this foil so that the remote control is ready
for operation.
The battery of the remote control is a long-life lithium cell. If
the range of the remote control is reduced during use, please
proceed as follows:
• Open the battery compartment on the back of the remote
control.
• Replace the cell by a battery of the same type. Ensure
correct polarity.
• Then close the battery lid.
If the remote control is not used for a prolonged period, remove
the batteries in order to prevent battery acid leaking.
CAUTION:
Batteries are not to be disposed of together with domestic
wastes. Dispose of the used batteries at the relevant collection
bin or at your dealer's.
WARNING:
Do not expose the batteries to high temperatures or direct
sunlight. Never throw batteries into the fi re. There is a danger
of explosion!
05-AR 773 DVD_GB.indd Abs1:31 05-AR 773 DVD_GB.indd Abs1:31
NOTE:
The signals from the remote control are transmitted to the
device by infrared light. You should therefore ensure that the
device is not in direct sunlight. This might make transmission
of the signals from the remote control to the device impossible.
Effective range of the remote control
Point the remote control at the remote control sensor on the
right next to the display on the front of the device. The distance
between remote control and sensor should not exceed 5m. The
angle of the remote control to the remote control sensor to right,
left, top and bottom should not exceed 30°.
Operation
(Illustration 2: Control Panel)
NOTE:
Some keys are to be found both on the device itself and
on the remote control. Keys with the same designation
have the same function.
1. BAND/ button
In radio mode:
Press the BAND/ button briefl y to switch between
the 3 FM bands and the 2 MW (medium wave) bands. The
designation of the corresponding level - FM1, FM2, FM3,
MW1, MW2 - is shown in the TFT.
In Bluetooth Mode:
Press the button to end the telephone call or reject an
incoming telephone call.
2. REL Button
Press the REL button to remove the front operating panel.
3. VOL Multifunction Button (Volume)
In the standard playback mode the multifunction button is
used for adjusting the volume. If the SEL button is pressed
beforehand, changes can be made in the menus, e.g. sound
mode.
4. RESET Button
Due to voltage fl uctuations in your vehicle electrical system
it is possible that the control processor of your radio has
„hung up". This is not a fault in the device! Press this
button with a pointed object to restart it (reset).
5. TFT Display (liquid crystal display)
6./12. / Buttons
a) In radio mode:
Move the SEL button in the direction of „ " or „ " in
order to set a radio station manually. Keep the SEL
Taste pressed down in the „ " or „ " direction in order
to start the search for a radio station.
31
19.10.2007 14:14:42 Uhr 19.10.2007 14:14:42 Uhr