Troubleshooting - Clatronic ar 773 Bedienungsanleitung

This device has been tested according to all relevant current
CE guidelines, such as electromagnetic compatibility and low
voltage directives, and has been constructed in accordance with
the latest safety regulations.
Subject to technical changes without prior notice!

Troubleshooting

Before going through the checklist please make all the
connections fi rst. If you still have questions after going through
the checklist, please consult your local customer service
representative.
Fault Symptoms Cause
CDs are drawn only The transport screws
half way into the CD have not been
tray. removed.
„NO DISC" is shown in The CD is inserted the
the display. wrong way round.
CD cannot be selected There is no CD
using the MOD(E) inserted.
button. A USB storage
medium is connected
to the USB port.
The CD does not The volume control is
play back after being set too low.
inserted into the The device has
device. not been correctly
connected.
CD works intermittently The surface of the road
(dropouts). is uneven.
The device is not fi rmly
installed.
The CD is damaged.
The CD is dirty.
The device may have
been installed in the
vehicle at the wrong
angle.
No function. The ignition is switched
off.
One or more fuses
have blown.
Device cannot be Incorrect connection
switched on or off via (each car manufacturer
the ignition. wires the ISO con-
nection in the vehicle
differently).
44
05-AR 773 DVD_GB.indd Abs1:44 05-AR 773 DVD_GB.indd Abs1:44
Fault Symptoms
The device does not
work correctly (EJECT,
LOAD, PLAY).
The device cannot be
operated, but „hangs
up".
No radio reception.
Solution
Remove the transport
screws.
Poor radio reception.
Insert the CD right way
round.
Insert a CD.
Remove the USB
storage medium.
In automatic search
Turn up the volume.
mode the radio does
not stop at a transmit-
Check the +12V and
ting station.
earth connection.
Wait until the road
becomes smoother
before playing the CD.
Install the device fi rmly.
Ensure that the rear at-
tachment is used if the
vehicle does not have
any suitable retainer
for the rear section of
the device.
Try another CD. If this
works correctly, the
fi rst CD is probably
damaged.
Clean the CD.
Please note that a
maximum inclination
of 20° degrees should
not be exceeded!
Turn the ignition key to
„ON" or „ACC".
Replace the fuse
by another 5 A /0,5
A fuse.
Please contact your
car workshop or a
vehicle specialist for
connection adapters
may specifi cally for
your model.
Cause Solution
The microcomputer Remove the CD and
has been interfered reinsert it.
Switch the device off
with by electromag-
netic fi elds. and on again.
The control processor Press the RESET
of the device may button.
have been blocked by
overvoltage or under-
voltage in the vehicle
electrical system.
The antenna cable is Insert the antenna
not connected. cable fi rmly into the
antenna socket of the
device.
It is possible that your Please contact your
vehicle has a special car workshop or a
antenna (phantom- vehicle specialist. (For
powered antenna.) other manufacturers
there are specifi c
phantom power supply
adapters and voltage
adapters available.)
The transmission Tune in to a radio
signals are too weak. station manually.
19.10.2007 14:14:52 Uhr 19.10.2007 14:14:52 Uhr