Maintenance And Cleaning; Disposal - Vieweg DC 1200 Bedienungsanleitung

VIEWEG
• P-Unit:
Pressing UP or DOWN key switches between PSI and BAR as unit for the digital
displayed pressure .
• P-Alarm:
By pressing the UP or DOWN key, the value for the low pressure alarm-limit can be
selected . If the input pressure is lower than the selected limit, the DC 1200 switches
to ALARM mode and no new dispensing is possible .
• Service:
The service counter shows the total number of dispensings the device has
performed . It is NOT resettable .
NOTE: Press the save key to store new settings. The unit will reboot itself.
If you do not want to store new settings, turn off the power and turn on again.

8 Maintenance and Cleaning

The dispensing controller is maintenance-free . Any needed repairs must be performed
by an authorized repair center or only by sending the unit back to VIEWEG GmbH .
To clean the unit and the housing, use only dry or damp cloths and never use cleaning
fluids such as gasoline, thinners or any other flammable or corrosive liquid .

9 Disposal

At the end of its service life, dispose of the controller in accordance with the applicable
local regulations .
Electrical parts can not be disposed along with household waste .
According to Directive 2012/19/EU on Waste Electrical and Electronic
Equipment (WEEE), electrical equipment must be returned to the
collection points set up for this purpose in order to be reused .
Operating Instructions DC 1200
30