Maintenance And Cleaning - Vieweg DC 200 Bedienungsanleitung

Operating Instructions DC 200
TIMER Mode
In the time control mode (TIMER), the device dispenses the material for the duration of
a preset time . This mode is useful if you want to dispense the same amount of material
several times in the operation .
5.2 Setting the dispensing time
DIP switches are located on the underside of the housing .
The table below provides time ranges that can be preselected
using these switches .
DIP 1 DIP 2
OFF OFF
ON OFF
OFF ON
OFF OFF
ON ON
ON OFF
OFF ON
ON ON
DIP switch 4 selects an extra option in which the signal is held at
ON and a manual mode is selected at OFF .
The precise adjustment within the time range is then made with
the rotary control on the front of the evice . (scale 0 - 10)

6 Maintenance and Cleaning

The dispensing controller is maintenance-free . Any needed repairs must be performed
by an authorized repair center or only by sending the unit back to VIEWEG GmbH .
To clean the unit and the housing, use only dry or damp cloths and never use cleaning
fluids such as gasoline, thinners or any other flammable or corrosive liquid .
DIP 3 Time Range
OFF 0,05 -
OFF 0,2 -
OFF 0,1 -
ON 0,01 -
OFF 0,3 -
ON 0,21 -
ON 0,11 -
ON 0,31 -
19
VIEWEG
0,4 sec .
20,0 sec .
10,0 sec .
1,0 sec .
30,0 sec .
21,0 sec .
11,0 sec .
31,0 sec .
EN