Operating Consoles; Arm Rest Control Panel; Device Carrier Control Assignments - Kärcher MC 250 Originalbetriebsanleitung

Low hydraulic oil level warning
Hydraulic oil filter malfunction
Warning, hydraulic oil temperature high
Seat contact switch malfunction
Engine air filter malfunction
Critical malfunction, switch off the engine
Warning, engine coolant temperature too high
Parking brake active
Reversing signal off
Warning, brake pressure too low
Warning, engine oil pressure too low
Switch off the engine
Engine fault warning
● If the engine fault is active, the warning lamp
lights up permanently
Water from the engine in the fuel
Engine fault in the exhaust treatment system
Warning, hydraulic circuits are automati-
cally vented (only when starting up for the
first time)
Warning, hydraulic controller offline
56
4

Operating consoles

4.1

Arm rest control panel

The control panel is located on the arm rest next to the
driver's seat. The arm rest can be individually adjusted to
suit the driver, see chapter "Setting the driver's seat".

4.1.1 Device carrier control assignments

Note
The indicators in the switches light when the switches are
switched on.
Left joystick
1
Right joystick
2
Not used
3
Switching the hydraulic system on/off
4
Not used
5
Not used
6
Electrical AUX 1 rear / AUX 3 front
7
Switching the rear PTO on/off
8
Not used
9
Electrical AUX 2 rear / AUX 4 front
10
English
Warning, display offline
Warning, speed is too high - reduce
speed
Warning, service brake faulty
Warning, parking brake faulty
Brake fluid warning
Warning, engine temperature high