Kärcher MC 250 Originalbetriebsanleitung Seite 55

2-wheel steering ready for selection
4-wheel steering activated
4-wheel steering ready for selection
Cruise control activated
Cruise control inactive
Cruise control (Resume)
Activate the previously set speed
Neutral position (middle position) of the travel
direction selector switch required
Steering error
Seat contact switch not recognized
Seat contact overwritten manually (bridged)
Service required
Preheating active
General fault (uncritical), check fault list
Fuel level warning
Perform the regeneration process
Engine malfunction (uncritical)
Warning, engine must be switched off
Warning, working hydraulics must be switched
off
Working hydraulics must be switched on
Axle load warning
Drive oil temperature warning
High hydraulic oil level warning
Reverse function active
Fog lights on
High exhaust temperature (regeneration is ac-
tive)
Regeneration is active (Inhibit)
Vehicle performance is limited, speed is limited
Warning, vehicle is in limited condition (trans-
port mode)
Warning, generator system is faulty
Warning, axle load too high
Drive oil temperature fault
DCU fault (control unit)
DCU in stop state
Warning, reversing not allowed
English 55