System Time/Timer Settings - Heidolph Hei-VOLUME Distimatic Pro Betriebsanleitung

Device description
Right push-and-rotary control
Standby button

System time/Timer settings

Touch the System time/Timer function button in the header of the start window for
about two seconds to open the selection window. In this window, you can set the
system time and select the desired display mode. The following options are available:
➜ Display of the current time (12- or 24-hour display, depending on the selection in
Settings
the menu).
➜
Stopwatch mode: In this mode, the actual elapsed time from the start of the
process is displayed.
➜ Timer mode: In this mode, the time remaining until the scheduled end of the
process is displayed.
This setting is applied in all operating modes and can be changed at any time!
▪ LED ring lights up orange when activated
▪ Function: Increase/decrease value, character
forward/backward, confirm value by pressing.
Press and hold both push-and-rotary controls simul-
taneously for approximately three seconds to lock the
display.
Press the standby button to put the device in standby
mode. Press the button again to put the device into
the previously active operating mode.
Pressing the standby button will stop the current
process!
93