Automatic Drainage Of Residue; Select Evaporator Type/Glassware - Heidolph Hei-VOLUME Distimatic Pro Betriebsanleitung

Commissioning

Automatic drainage of residue

Formats
In the menu, you can define whether the residue is automatically drained
from the evaporation flask (blowing out in overpressure mode), or whether the flask is
drained by hand.
with automatic drainage of residue
A system
be operated automatically in continuous operation (condition: continuous supply with
educt!).
Operation with automatic drainage of residue
with automatic drainage of residue
In operation
cally drained under the following conditions:
– Stagnation reached in sensor mode.
– Distillate drain counter expired in sensor mode.
– Refill counter expired in sensor mode.
– Additional evaporation time for distillate drain or refill counter has expired in
sensor mode.
– Number of defined steps (filling/evaporation) reached in time mode.
Operation without automatic drainage of residue
without automatic drainage of residue
In operation
flask must be drained by hand.
Selection automatic drainage of residue
➜ The active selection is highlighted in orange when the
To change, touch the desired function button
Residue Extraction
➜ Confirm the new setting with
confirmation prompt!
➜ Touch the button

Select evaporator type/glassware

Formats
In the menu, you can define the connected evaporator type including the
glassware used. The selection stored in the system appears in the form of function
buttons:
➜ The active selection (in the example: Hei-VAP Industrial with set of glassware R) is
highlighted in orange. Touch the desired function button to switch between options.
➜
Confirm the new setting with
confirmation prompt!
➜ Touch the button
The selection evaporator type/glassware is necessary for display
purposes only, see also section "Control panel" on page 90!
.
. The change is accepted immediately without a
to discard the change.
. The change is accepted immediately without a
to discard the change.
107
, in sensor or time mode can
, the residue is automati-
, the evaporation
Formats
menu is opened.
with / without automatic.