Heidolph Hei-VOLUME Distimatic Pro Betriebsanleitung Seite 137

Operation
Procedure
➜
Touch the button
– The vacuum pump is switched on, the pressure in the evaporation flask is
lowered to process pressure.
– In the footer, the
➜
Touch the button
flask.
By briefly tapping the
injected into the evaporation flask.
Touch the
(observe button progress) to fill the evaporation flask continuously.
The filling has to be stopped manually!
➜ Touch the button
Stop process
➜ Touch the
When the process is ended, the
appears on the control panel.
➜ Touch the button
approx. 30 s).
Drain distillate
➜
Touch the key
The evaporation flask must be drained by hand.
Please observe the relevant information and instructions in the
operating instructions for the rotary evaporator!
Start process
.
Fill educt
and
Fill educt
to start the automatic filling of the evaporation
Fill educt
Fill educt
Fill educt
again to stop filling.
button to stop the process (end process).
Drain distillate
Stop process
button, a small amount can be
button for approximately 2 seconds
Drain distillate
 The distillate is drained (default:
 Drainage of the distillate is stopped.
136
buttons are displayed
button