Parameters Hei-Vap; Data Logging - Heidolph Hei-VOLUME Distimatic Pro Betriebsanleitung

Operation
Max. drain
distillate:
additional
Evaporation time
Forced draining
collector
Standby timer
after educt
container runs
empty

Parameters Hei-VAP

Parameters Hei-VAP
In the sub-menu
Hei-VAP can be stored (vacuum, hysteresis, rotational speed, heating bath temperature,
recirculation chiller temperature).
These values are for informational purposes only and may be included in a new recipe.
Parameters Hei-VAP
Touch the
the sub-menu and enter the desired values of the connected rotary evaporator by hand.

Data logging

See section "Data Recording" on page 108.
Selectable if a specific number of distillation drainage steps
is specified in the start window:
In the example: five distillate drainages, then optionally
an additional evaporation time runs. This allows a desired
concentration to be achieved!
max. filling: Add. Evaporation
The parameters
time max. drain distillate: additional
and
Evaporation time
be activated at the same time!
Forced draining collector active: Collector will be drained
after 1 – 9999 seconds, regardless of the filling level.
Range: 1 – 9999 s.
Activate/deactivate forced draining of the collector (deter-
mines previous parameter!).
Range: active / inactive
Time until the standby mode is activated after the educt
container runs empty.
Range: 1 – 9999 s.
various parameters of the connected
button in the footer of the
122
are mutually exclusive and cannot
Default
view to open