Werbung
SUM ?
SUM xxx
SYNF ?
SYNF 0 or OFF
SYNF 1 or ON
'T'
TOL ?
TOL
+|-xxx.yyyyyy
+|-xxx.yyyyyy
+|-xxx.yyyyyy
TOL 0 or OFF
TOL 1 or ON
TOLM ?
TOLP ?
TOLP 0 or OFF
TOLP 1 or ON
TOLS ?
'U'
UNI ?
'V'
V
VER ?
A.2 COM port USB, transmission errors
Code
ERR0
ERR1
ERR2
ERR3
ERR4
ERR5
ERR6
ERR7
ERR8
ERRA
ERRB
CALx.ERR
CORx.ERR
A
Px.ERR
TEMP .ERR
Returns the user probes reading summation
Modify the user probes reading summation (1...200)
Returns the probe synchronization status (D304y only
Independant probe reading (default)
Synchronized probe reading (D304y only)
Returns the tolerances set (Nominal value, Tolerance A, Tolerance B, function status and
measuring symbol)
Enters the tolerances set (Nominal (+/- 9999.99999mm/390''), Tolerance A, Tolerance B
(+/- 400mm/15''))
Signs are recommended.
Tolérance A > tolérance B : External measurement
Tolérance A < tolérance B : Internal measurement
Deactivates the tolerances
Activates the tolerances
Returns the print status of the min / max measure
Returns the print status of the tolerances
Deactivates the print of the status of the tolerances
Activates the print of the status of the tolerances
Returns the print status of the current measure
Returns the current unit mode (MM or IN)
Returns the firmware version
Returns the version and date of software (Vx.yza)
Type of errors
Command not executed, deactivated function
Parity error
Unknown format
Timeout
Capacity Overflow, more than 100 characters without CR
Command not executed, unauthorized function.
Overrun error
Frame error
Break of transmission error
Not critical error of Flash memory
Critical error of Flash memory (RX and TX LEDs turned on)
Invalid calibration procedure on probe x
Invalid correction point to point on probe x
Probe x error (not connected)
Temperature not stabilized (CAL or COR remote command)
58
Werbung
Kapitel
