Changing Bre Offset - Francotyp-Postalia FPi 6600 Betriebsanleitung

2. Use the arrows next to "Document offset" to change the Document offset for the
selected job.
The vertical transport of documents fed by the various feeders is arranged in such a
way that the documents are partially overlapping each other. This overlapping scheme
ensures that the documents are properly aligned in the collator area.
In the "document offset" menu you can set the extend to which the documents are not
overlapping each other, i.e. the document offset value. The default value is 50 mm
(2.0 inch). The document offset can be varied between 20 mm (0.8 inch) and 250 mm
(9.8 inch).
3. Press the [Save] button to save the changes to the selected job.

Changing BRE Offset

To change the BRE offset for a selected job:
1. Use the arrows next to "Select job" to select for which job (Job 1-25 or Auto) you want
to make the changes.
6
81