Document Separation - Francotyp-Postalia FPi 6600 Betriebsanleitung

Document Separation

The term 'Document separation' refers to the adjustment required for separating the upper
document from the rest of the documents in the stack. This prevents pulling too much
documents from the stack at the same time.
The document separation for the automatic feeders is set automatically; there are no manual
adjustments needed.
Feeders 1 and 2 (the feeders in the two lowest positions) can be special feeders. The
4
document separation for special feeders must be adjusted manually. While special feeder
trays fit in all positions, adjusting the separation is only possible when they are fitted on
position 1 and 2.
Adjust the separation of special feeders as follows:
1. Push the knob A forward until it clicks.
2. Place a document on the feed tray and slide it about 60 mm (2.4 inch) into the system
(turn the knob A counter clockwise if the separation is set too narrow).
3. Push the document between the separation rollers, which are behind the rubber paper
pullers.
4. Turn the knob A clockwise to get more resistance or counter clockwise to lower the
resistance.
The separation is adjusted correctly when a slight resistance is felt on the document.
5. Pull the knob A back again when ready.
42
Adjusting the separation (using a special feeder) is especially
important when you want to process glossy materials.