Installing The Versafeeder - Francotyp-Postalia FPi 6600 Betriebsanleitung

Installing the VersaFeeder

When installing the versaFeeder directly to the inserter, install the module in the following
manner:
1. Disconnect the inserter connecting cable from the feeder module. Put the connecting
cable to the right hand side of the feeder module.
2. Place both hands under the left and right-hand side panel of the feeder module to
unlock it from the inserter.
3. Lift and uncouple the feeder module from the inserter. Move it backwards to create
enough space for the versaFeeder.
4. Place the versaFeeder between the inserter and feeder module. Place both hands
under the left and right-hand side panel.
5. Lift it above the inserter fixing plates and lower it until it locks into place. Both sides
are now locked.
6. Place both hands under the left and right-hand side panel of the feeder module.
7. Lift the feeder module above the versaFeeder fixing plates and lower it until it locks
into place. Both sides are now locked.
8. Connect the 12-pole connector of the inserter to the 12-pole socket located on the
right-hand side of the versaFeeder.
9. Connect the 12-pole connector of the versaFeeder to the 12-pole socket of the feeder
module.
The power inlet is located on the right-hand side of the feeder and contains the main
fuse.
Always switch off the system before connecting to, or disconnecting
from any attached units.
3
29