Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Support for Curved Reply Envelopes (option for
VersaFeeder)
Depending on the quality of the paper, the conditions during storage, etc. envelopes can
be curved. This can cause smaller reply envelopes to skew while being processed by the
versaFeeder.
A special support is available to allow curved envelopes to be correctly processed. It can
be used for envelopes with a height up to 110 mm (4.33").
To attach the support onto the hopper platform and adjust the support:
1.
Hold the support as indicated by the figure.
2.
Place both notches C at both sides into the sleeves.
3.
Lower the other end of the support. It will lock fully into place.
4.
Loosen knob B slightly by turning it counterclockwise.
5.
Move support in or outwards until the ruler indicates the height of the envelope (the
side of the plate A is indicator).
6.
Turn knob B clockwise to tighten the support.
3
33
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
