3
Options
MaxiFeeder
The maxiFeeder is a feeder that can be loaded with a high number of documents. This
3
feeder is intended to be used for Business Reply Envelopes (BRE), but also 'standard'
documents up to 356 mm (14") length can be processed with it.
Installing the MaxiFeeder
The maxiFeeder should be installed at the position of feeder no. 1 and/or 4. If you install
the maxiFeeder on position 4, you cannot use position 2 and 3 for document feeders.
To install the maxiFeeder as follows:
1.
Lift the paper feed rollers with the front edge of the maxiFeeder.
2.
Move the maxiFeeder forward until it hooks behind the frame axle.
3.
Connect the connector A to the socket B.
The maxiFeeder is auto-detected by the system when the system is switched on. This
makes it easy to switch over from the standard document feeder tray to the maxiFeeder
and vice versa.
To make use of a maxiFeeder it is not necessary to (re-)program the jobs.
22
To allow easier hooking on of the maxiFeeder it is advised to put
the feeding plate in the rear position.