Adjusting The Envelope Insert Fingers - Francotyp-Postalia FPi 6600 Betriebsanleitung

Adjusting the Envelope Insert Fingers

To make a good insert of the document set into the envelope, the insert fingers A should
be about 5 mm (0.2 inch) inside the envelope.
The outer fingers D should be about 5 to 10 mm (0.2 to 0.4 inch) from the edges of the
envelope.
4
To verify that the position of the fingers is correct:
1. Choose a job and press the [1x] button.
2. Follow the steps in the wizard.
To adjust the envelope insert fingers:
1. Loosen the knurled knob C on top of each finger.
2. Adjust each finger so that the tip enters about 5 mm (0.2 inch) into the envelope.
3. Re-tighten the knurled knob.The fingers can be moved sideways to the desired position.
4. Place the outer fingers about 5 to 10 mm (0.2 to 0.4 inch) from the edges of the
envelope.
46
Check the position of the insert fingers when changing to a different
type of envelope.