Belden HIRSCHMANN EAGLE40-07 HiSecOS Referenzhandbuch Seite 770

show ip ospf interface 2/1
IP address..................................... 10.0.2.2
OSPF admin mode................................ enabled
OSPF area ID................................... 1.1.1.1
Transmit delay................................. 1
Hello interval................................. 10
Dead interval.................................. 40
Re-transmit interval........................... 5
Authentification type.......................... none
OSPF interface type............................ broadcast
Status......................................... not Ready
Designated Router.............................. 0.0.0.0
Backup designated Router....................... 0.0.0.0
State.......................................... down
MTU ignore flag................................ disabled
Metric cost.................................... 1
configure
ip routing
exit
Nehmen Sie die entsprechende Konfiguration auch auf den anderen OSPF-Routern vor.

show ip ospf neighbor brief
Neighbor ID
------------
10.0.2.1
show ip route all
Network Address
---------------
10.0.1.0
UM Config EAGLE
Release 03.5 08/2020
Anzeige der Einstellungen für die OSPF-Interface-
Konfiguration.
Wechsel in den Konfigurationsmodus.
Die Routing-Funktion global einschalten.
Wechsel in den Privileged-EXEC-Modus.
Anzeige der OSPF-Adjacencys.
IP Address Interface
----------- -----------
10.0.2.1 2/1
Anzeige der Routing-Tabelle
Protocol Next Hop IP
-------- --- -------
OSPF 10.0.2.1 2/1
State Dead Time
------ ----------
Full
Next Hop If Pref Active
----------- ---- ------
110 [x]
Routing
12.7 OSPF
205