PeakTech 2170 Bedienungsanleitung Seite 62

Note:
1. When Auto-LCR mode is active, the secondary parameter
will show the equivalent resistance in parallel mode (Rp) to
replace the D factor if the C measured value is less than
5pF.
2. In order to avoid damaging the instrument, the capacitance
requires discharge before measuring.
8.3. Resistance measurement
1. Turn on the power.
2. Insert the measured resistance into the input terminal
directly or:
3. Connect the alligator clips to the ends of the measured
resistance.
4. Insert "Open" Adapter to direct measurement sockets
6. The default test mode is Auto LCR mode, the resistance
value will show on primary display and the phase angle θ
will be shown on secondary display. In Auto LCR mode,
the D/Q/ESR key, SEL/PAL key, SORTING key and
REL% key are not available.
7. Press FUNC.-key three times to select Auto-R (ACR)
mode. The primary LCD display will show the resistance
value. The secondary parameter is omitted and the
D/Q/ESR key is not available.
8. Press FREQ
100/120Hz/1/10/100 kHz.
9. Press SER/PAL key to select series or parallel mode.
key to select
62
frequency value: