PeakTech 2170 Bedienungsanleitung Seite 61

8.2. Capacitance measurement
WARNING: If there exist voltage in the capacitor (charged),
connect the two ends of the capacitor for a short time to
discharge. Otherwise, the device can be damaged through
overvoltage.
1. Turn on the power.
2. Insert the positive polarity of capacitance into the positive
terminal and its negative polarity into the negative terminal
or:
4. Insert the black and red testing lines with alligator clip into
the "L
CUR
respectively. Connect the alligator clips to the two ends of
capacitance corresponding to its polarity.
5. Insert "Open" Adapter to direct measurement sockets
6. The default test mode is Auto LCR mode, the capacitance
value will be shown on primary display and the dissipation
factor D will be shown on secondary display. In Auto LCR
mode, the D/Q/ESR key, SEL/PAL key, SORTING key and
REL% key are not available.
7. Press FUNC.- key twice to select Auto-C mode. The
primary LCD display will show the capacitance value. The
secondary LCD display will show the dissipation factor D.
The quality factor Q, equivalent resistance ESR/Rp or
phase angle θ can also be shown by pressing the
D/Q/ESR key.
8. Press FREQ key to select frequency value: 100/120
Hz/1/10/100 kHz.
9. Press SER/PAL key to select series or parallel mode.
", "L " terminal and "H
POT CUR
61
", "H " terminal
POT